110A ESC with Heat Sink BEC, Suitable for 2S-6S Airplane, Glider or Heli
Features
- Smooth forward operation
- Extremely low resistanc32KHz Frequency operation
- P.O.R Power on reset
- Easy user programmable features.
- Audible arming signal
- microprocessor controlled
- B.E.C: 5.0V / 3.0A
- Programmable low volt cut off for Li-Po
- Safe start protection
- micro size allows for ease of installation
- Programmable motor rotation
Specifications
Item Size 88 x 29 x 17 mm
Item Weight 65.5 g
Max Continuous Current 110 Amps
Operating Voltage Range 6 to 15V
On Resistance 0.78 mOHM
Max BEC Output 4 Amps @ 5.0V
2S~6S Lithium, 6~19 Cell Ni, with heat sink
The output is rated at 388 watt. Under this watt, the speed control will work normally. When the watt approximately reaches to 410~420, it will automatically shutdown to prevent the over load to the speed control.
Temperature protection: When the temperature reaches to 95 degree C, the speed control will slowdown and the output will reduce 50% (the on board LED will turn on). You have to move the throttle stick to idle position and then the speed control will re-work once you throttle up again.
DO NOT install a motor which rating is larger than the speed control’s limit to avoid damage or burn down.